Showing posts with label cable. Show all posts

Monday, May 15, 2017

How to Make a Network Cable

Making Ethernet Cables - Tricks of the Trade

HOW TO MAKE AN ETHERNET CABLE

Purchasing fully made Ethernet cables from the store can be quite expensive. It is far easier to simply buy a box of bulk Category 5e Ethernet cable and then attach your own RJ-45 connectors to the cut ends of your preferred cable length.

Bulk Ethernet Cable - Category 5e or CAT5e

(You may also use Category 6 or CAT6 cabling which has higher performance specifications and is about 20% more expensive than CAT5.)

Bulk RJ45 Crimpable Connectors for CAT-5e

Bulk RJ45 Crimpable Connectors for CAT-6

RJ-45 Crimping tool

There are two kinds of Ethernet cables you can make,
Straight Through and Crossover.STRAIGHT THROUGH
Ethernet cables are the standard cable used for almost all purposes.
It is highly recommend you duplicate the color order as shown on the left.
Note how the green pair is not side-by-side as are all the other pairs.
This configuration allows for longer wire runs.

CROSSOVER CABLES - The purpose of a Crossover Ethernet cable is to directly connect one computer to another computer (or device) without going through a router, switch or hub.

Heres how to make a standard cable:

cut into the plastic sheath about 1 inch (2.5 cm) from the end of the cut cable. The crimping tool has a razor blade that will do the trick with practice.

Unwind and pair the similar colors.

Pinch the wires between your fingers and straighten them out as shown. The color order is important to get correct.

Use scissors to make a straight cut across the wires1/2 Inch (1.3 cm) from the cut sleeve to the end of the wires.

Push the wires into the connector. Note the position of the blue plastic shielding. Also note how the wires go all the way to the end.

A view from the top. All the wires are all the way in. There are no short wires.

WRONG WAY - Note how the blue plastic sleeve is not inside the connector where it can be locked into place. The wires are too long. The wires should extend only 1/2 inch from the blue cut sleeve.

WRONG WAY - Note how the cables do not go all the way to the end of the connector.

Criming Ethernet

CRIMPING THE CABLE ... carefully place the connector into the Ethernet Crimper and cinch down on the handles tightly. The copper splicing tabs on the connector will pierce into each of the eight wires. There is also a locking tab that holds the blue plastic sleeve in place for a tight compression fit. When you remove the cable from the crimper, that end is ready to use.

Ethernet Repeat Steps

For a standard "Straight Through" cable, repeat all steps and wire color order on the other end of cable. For a cross-over cable, the other end will have a different color order as shown by the crossover picture above.

Make sure to test the cables before installing them. An inexpensive Ethernet cable tester does this quite well.

Available link for download

Amazon Prime Video Launched How to Join Free Trial A big competition to DTH Cable

Amazon Prime Video Launched How to Join Free Trial A big competition to DTH Cable
Read more »

Available link for download

Best Download 2017

Monday, May 15, 2017

How to Make a Network Cable

How to Make a Network Cable

Making Ethernet Cables - Tricks of the Trade

Monday, April 3, 2017

Amazon Prime Video Launched How to Join Free Trial A big competition to DTH Cable

Amazon Prime Video Launched How to Join Free Trial A big competition to DTH Cable